I'm in an Interior Design class and the tech specialist on campus asked the class if we would design his classroom, as we have already done another teacher's room. We asked him his budget and what he liked and the class came up with a story board. We presented our ideas and he didn't like a little bit of it so we tweaked it to be exactly what. I landed on making three shelves with frames of car related things because that's what he likes. Here's how!
I went out and bought 2 1x4's and 1 1x2. I went to Home Depot and they cut each 8' piece into 22" piece sections for the 3 shelves.
While I was there, I picked up some minwax stain in the color "Dark Walnut", because I found it works best.
Then I stained the wood (and my hands).
(pictured is only pieces for two shelves!)
It's time to start gluing! I used gorilla glue because everyone knows that's the best. I glued one of the 22" 1x4 to another 22" 1x4 piece like this.
Again, I let that sit over night to make sure its set all the way. After that, I drilled in pilot holes for the screws. I did one at 11" because its the middle and then from the outsides, I went in 2 1/2". I chose some dark screws to match the dark stain so it wouldn't be as noticeable.
Woohoo! You're done! Here's the final product! I love the way it turned out!
No comments:
Post a Comment